What about the problems on installation of ultrasonic cleaning transducers?
Deixe um recado
In the production of small ultrasonic cleaning machine, the ultrasonic transducer pasted at the bottom of the ultrasonic cleaning tank or on the side wall is distributed too closely, the installation method is not scientific, and a close arrangement. Input ultrasonic head power intensity of 2-3 watts per square centimeter, such a high strength on the one hand will speed up the stainless steel plate surface (contact with ultrasonic vibrator surface) cavitation corrosion, shorten the service life, (Kelisonic ultrasonic cleaning machine contact surface all electroplated hard chromium processing, On the other hand, the sound intensity is too high. A large number of large bubbles will be generated near the surface of the steel plate, which will increase the sound transmission loss and resonance phenomenon, and weaken the cleaning effect far away from the ultrasonic transducer. Generally, the power intensity per square centimeter is less than 1.5 watts is appropriate (according to the area of the steel plate with ultrasonic transducer). If the cleaning tank is deep, in addition to the bottom of the tank adhesive ultrasonic transducer, in the wall of the tank should also be considered bonding ultrasonic transducer. The bonding quality of ultrasonic shock head and cleaning tank has great influence on the quality of ultrasonic cleaning machine. Not only to stick, but also need to install the thickness of the steel plate of the ultrasonic cleaning tank to add a certain torque. The installation requirements of the ultrasonic transducer are as follows: Plate thickness 1.5mm set torque shall be 5N.m plate thickness 2.0mm or 2.5mm set torque shall be 5N.m and the rubber layer is required to be uniform, no lack of glue and no cracks are allowed, so that the ultrasonic energy can be transmitted to the maximum extent of the cleaning liquid, in order to improve the efficiency of the machine and cleaning effect. At present, some cleaning equipment to prevent the transducer from falling off the cleaning tank. Screw and adhesive fixation method is adopted. Although the transducer will not fall down in this connection, there are many hidden dangers. If the screw welding quality is poor, such as not perpendicular to the surface of the stainless steel plate, the rubber layer is not uniform, or even crack or lack of glue, energy transmission will be weakened; On the other hand, if the welding is not good, it will also affect the smooth surface of stainless steel, resulting in accelerated cavitation corrosion and shortened service life.






